Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Static route question

Hello,

I have a setup with 2 networks connected to the XG firewall via a switch:

 

Port 1 is connected to the 10.0.0.x/24 network switch.

On that switch is a Sophos UTM with an IP of 10.0.0.6 (it has its own internet connection, etc., 10.150.x.x is it's subnet). 

If I go to a computer on the 10.0.0.x/24 network, and I add a static route (i.e. on the mac its command is  route add 10.150.0.0/16 10.0.0.6) I can route traffic between that computer and the 10.150.x.x network just fine, however that's not a good situation because I dont want to add that static route to each computer on the network.  I know also because of this, firewall rules are setup correctly to allow traffic between both subnets.

How do I get a static route in the XG to work that same way?

Right now, I have one setup as  but that doesn't work.  I know this doesn't work as I can take any other computer on the 10.0.0.x subnet and cannot ping to 10.150.x.x network.

Any ideas?



This thread was automatically locked due to age.
Parents Reply Children
No Data