Hi, and welcome to the UTM Community!
Rather than disable UDP flood protection for everything, check the Intrusion Prevention log to see what Exception(s) you need to add.
Cheers - Bob
We have had the same problem in our company for about 4 weeks.
Two locations Site to Site VPN:
Location 1: SG135, 500/500 Mbit, FW: 9.605-1
Location 2: SG125, 100/30 Mbit FW: 9.605-1
Since the last firmware update the SitetoSite VPN is extremely slow. I can only get a speed of exactly 780 KB/s.
Before the update we were able to use the full bandwidth.
Both tunnels have already been deleted, restarted the Firewall´s and tunnels newly set up. No improvement.
IPS is not used at either site and MTU support is also active.
Any ideas?
Thanks
We have had the same problem in our company for about 4 weeks.
Two locations Site to Site VPN:
Location 1: SG135, 500/500 Mbit, FW: 9.605-1
Location 2: SG125, 100/30 Mbit FW: 9.605-1
Since the last firmware update the SitetoSite VPN is extremely slow. I can only get a speed of exactly 780 KB/s.
Before the update we were able to use the full bandwidth.
Both tunnels have already been deleted, restarted the Firewall´s and tunnels newly set up. No improvement.
IPS is not used at either site and MTU support is also active.
Any ideas?
Thanks