Hi,
I recenetly installed a RED at a remote site and cousn't get it to provide a stable connection back to our UTM.
Looking at the UTM logs it constantly cycles with the following
This thread was automatically locked due to age.
Hi,
I recenetly installed a RED at a remote site and cousn't get it to provide a stable connection back to our UTM.
Looking at the UTM logs it constantly cycles with the following
Hi Richard Priest,
I have had issues with a RED15, and the first thing I always do is switch off compression, Sophos has never fixed this properly, and also I have had issues with the MTU size on the RED end...
The RED15 in a Data-Center it would disconnect every 3-4 days, until I checked the firmware and found that the MTU was set incorrectly, so updated firmware and changed MTU, now it would only disconnect every 2-3 weeks.
then if it did disconnect and then not re-connect I would reboot the router in front of the RED and all would be fine (for the next couple of weeks).
I have a SG310 on a 40/100 fibre circuit, the data-center had 10/100 Ethernet circuit connected via a router (many were tried, finally settled on Draytek283x) and the RED15 was behind the router. I had no issues until the 9.5 updates then it all went south.
I was using this as a (off-site) backup so this would be constantly running at full tilt all the time. Loading may have been another issue to contend with.
I hope this helps you out
XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!
Hi Richard Priest,
I have had issues with a RED15, and the first thing I always do is switch off compression, Sophos has never fixed this properly, and also I have had issues with the MTU size on the RED end...
The RED15 in a Data-Center it would disconnect every 3-4 days, until I checked the firmware and found that the MTU was set incorrectly, so updated firmware and changed MTU, now it would only disconnect every 2-3 weeks.
then if it did disconnect and then not re-connect I would reboot the router in front of the RED and all would be fine (for the next couple of weeks).
I have a SG310 on a 40/100 fibre circuit, the data-center had 10/100 Ethernet circuit connected via a router (many were tried, finally settled on Draytek283x) and the RED15 was behind the router. I had no issues until the 9.5 updates then it all went south.
I was using this as a (off-site) backup so this would be constantly running at full tilt all the time. Loading may have been another issue to contend with.
I hope this helps you out
XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!