This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Route to specified IP Standard/Unified Mode

Hi,

 

we need following result on our customer. There is a external Server, and it only allows to connect to this server with the publicip from the branch, but we need to use the RED Tunnel in standard/Uni mode. Is there a Way to set a policy to connect one single device in the branch with this public ip to the destination server?

please look to the szenario in the image i attached.

thanks :)



This thread was automatically locked due to age.
Parents
  • The only solution is a Full NAT in the UTM.

    Here in the USA, an SG 115 with 6 years of Network Protection is less expensive than a RED 50 with three warranty extensions.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • The only solution is a Full NAT in the UTM.

    Here in the USA, an SG 115 with 6 years of Network Protection is less expensive than a RED 50 with three warranty extensions.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data