This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cable Modem + DHCP + HA = Not working

We have two 220's setup as a hot standby HA set.  The T1 link has been working fine.

Recently we decided to add a backup Internet link and had a cable modem installed from Cox Communications.  I setup the new link, but I cannot get DHCP to configure an IP address when it is connected to the 220's.  I have the cable modem plugged into an HP switch, along with port eth4 from the 220's.

However, if I plug the cable modem directly into 1 of the 220's (the active one), it will get an IP address and route packets.  But as soon as I connect it through the HP switch to both 220's, DHCP stops working.

I also tried plugging in a laptop to the cable modem and that also works.

I have all of the used ports on the 220's connected to the same HP switch with static VLAN's setup.  Here's a list of the ports on the 220's and what they are used for:
eth0: LAN
eth1: T1
eth2: DMZ
eth3: HA
eth4: New Cox link
eth5-7: not used

I've tried looking through the logs, but I haven't found anything that seems useful.


This thread was automatically locked due to age.
Parents Reply Children
No Data