This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LAN1 WAN1 / LAN2 WAN2 with no redundancy

Hello,

I'm new in this forum,

I have a sophos UTM120, and I have 2 Wans and 2 Lans,

I bided LAN1 > WAN1 and LAN2 > WAN2, it works pretty good when both of WAN are connected and not down,

I would like to choose definitely LAN1 > WAN1 and LAN2 > WAN2 with no redundancy even when a WAN go down,

Is it possible?

Thanks in advance



This thread was automatically locked due to age.
Parents
  • I also uncheck the box Skip rule on interface error, but even with this box uncked he swith form WAN1 to WAN2, please help.

  • Salut Raouf and welcome to the UTM Community!

    Please show a picture of the edit of your Multipath rule with 'Advanced' open.

    Sometimes it takes a few minutes for the configuration daemon to redo the underlying rules after you apply a change in WebAdmin.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • Hello,

    Thank you very much for your support,

    Please find bellow the picture of the edit of Multipath rule.

    I just tested I think it works when I switched the position of WAN2 on first position !

    I also joined a picture of NAT, is it correctly configured? I would like to use only WAN 2 to VPN access with DyDNS.

    With Best regards

     

  • Good work - that looks great Raouf.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply Children
No Data