This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP100C does not receive IP address

Hi,

I received today an XG135 and a AP100C. So far I configured Port 4 to be in WLAN zone and to be DHCP.

The XG is not showing any IP address on the port. The communication seems to be established looking at the LAN ports.

But the AP flashes after booting up orange. Meaning waiting for DHCP.

I guess I'm doing some basics wrong.

Any help areciated.

BR, Frank



This thread was automatically locked due to age.
Parents
  • Hi Frank,

     

    could you provide screenshots of your interface config and your dhcp config for further troubleshooting?

    (IP-Adresses should be blackened)

     

    Regards,

     

    Ole

  • Hi Ole,

    thanks for reply. I reinstalled the FW of the XG with the latest version with factory defaults.

    In this configuration all ports are defined in LAN zone as a bridge (except port2).

    I could find and configure my AP and defined some SSIDs. That works great.

    Looks like I did something wrong while configuring zone WLAN and it's port.

    Regards, Frank

Reply
  • Hi Ole,

    thanks for reply. I reinstalled the FW of the XG with the latest version with factory defaults.

    In this configuration all ports are defined in LAN zone as a bridge (except port2).

    I could find and configure my AP and defined some SSIDs. That works great.

    Looks like I did something wrong while configuring zone WLAN and it's port.

    Regards, Frank

Children
No Data