This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Utilizing Eth1 on APX 530/740 as an access port (un-tagged in a VLAN)

I've already read this: https://community.sophos.com/kb/en-us/133199 (APX 530 / APX 740 ETH1 Interface FAQ)

I am not using VLAN 1, it is default and used for STP which AP does not participate in.

VLAN 2 = Corp Network (work stations)

VLAN 3 = Guest

Current Config:

Network Switch PoE+ --> Switchport Trunk VLAN's 2 & 3 --> APX 530 bridged to SSID Corp (VLAN2) & Guest (VLAN3)

 

I'd like to un-tag Eth1 on VLAN 2 (corp network) and connect a workstation. It is not ideal but I need to recoup the port as this is existing construction and no other low voltage cabling can be installed & the desktop does not do wireless. What I would like this to look like is this:

 

Network Switch PoE+ --> Switchport Trunk VLAN's 2 & 3 --> APX 530 Bridged to SSID Corp (VLAN2) & Guest (VLAN3) And... Eth1 is Access Port VLAN 2 / un-tagged VLAN 2

 

Thanks,

Chris

PS. My hunch is the there is no built in SW in the AP and the two Eth Ports are the same, except Eth0 has PoE input.



This thread was automatically locked due to age.