Knowledge Base

Failsafe Mode Cyberoam boots up in Failsafe Mode EITHER when the virtual appliance is configured with less than the base virtual hardware configuration OR when one or more of its system cr

Applicable to Version: 10.04.0 Build 255 onwards Yes, you can delete a virtual network interface from Cyberoam Virtual UTM Appliance. · If the virtual network interface you wan

Applicable Version: 10.04.0 Build 255 onwards Following features are not supported by Cyberoam Virtual Security Appliance: - 3G/4G - WLAN - LA

Applicable Version: 10.04.0 Build 255 onwards Cyberoam Virtual Security Appliance supports configuration of maximum of 26 vNICs. However, this number varies according to the Virtualiza

Applicable Version: 10.04.0 Build 255 onwards There underlies a base virtual hardware configuration requirement without which Cyberoam Virtual Security Appliance goes into “FAILSAF

Applicable Version: 10.04.0 Build 255 onwards Procedure to restore backup from physical Cyberoam Security appliance to Cyberoam Virtual Security Appliance: 1. Power down the Guest OS

Applicable Version: 10.04.0 Build 255 onwards Upgrade of your Cyberoam Virtual Security Appliance is to be done in Two (2) scenarios: - If you want to purchase a

Applicable Version: 10.04.0 Build 255 onwards You can obtain a Cyberoam Virtual Security Appliance by following the steps below: 1. Place an order with your reseller/distributor.