Data Control and DLP
Endpoint Security and Control
Sophos UTM 9
Sophos Firewall Manager
Sophos iView V2
Tweets by SophosSupport
Sophos XG Firewall: WAN load balancing CLI command
Created: 26 Apr 2019
This article describes how to set up the WAN link load balancing type on the firewall.
Sophos XG Firewall : Unable to change the priority for IPSec VPN site-to-site tunnel over SSL VPN site-to-site tunnel
Created: 27 Feb 2019
This article describes about behavior regarding unable to change the priority for IPSec VPN s2s tunnel over SSL VPN s2s tunnel configured.
Sophos XG Firewall: How to forward multicast traffic over an IPsec VPN connection
Created: 22 Jan 2019
This article describes how to forward multicast traffic over an IPsec VPN connection.
Sophos XG Firewall: How to resolve issues when an IPSec tunnel uses an alias WAN interface
Created: 4 Jan 2019
This article shows the steps required to enable source based routing over an alias WAN address.
Sophos XG Firewall: How to configure BGP
Created: 9 Oct 2018
This article describes how to configure BGP in the Sophos XG Firewall.
Sophos XG Firewall: How to configure Routing Information Protocol (RIP)
Created: 10 Sep 2018
This articles describes how to configure RIP in the Sophos XG Firewall.
Sophos Firewall: How to change multicast group limit for OSPF
Created: 9 May 2017
Multicast group limit for OSPF is set to 20 by default. This article illustrates how to custom this value.
Sophos XG Firewall: How does Sophos XG Firewall deal with ARP Flux?
Created: 29 Jan 2016
ARP Flux is disabled by default in Sophos XG Firewall. Thus, if multiple interfaces are connected to a single subnet, only the respective interface will respond to ARP requests. This ensures accurate MAC-to-Port mapping.
Sophos XG Firewall: How to configure a floating static unicast route
Created: 29 Jan 2016
A floating static unicast route is a low priority route that has a greater Administrative Distance than other dynamic or static routes. It acts as a backup route that is used when the other higher priority routes fail.
Sophos XG Firewall: How to configure PIM-SM routing
Created: 27 Jan 2016
Sophos supports PIM version 2 and PIM-SM mode with the Rendezvous Point (RP) selection method as BSR (Bootstrap Router). This article describes how to configure PIM-SM routing.