This article describes the steps to check which component in the Exploit Prevention is causing performance issues on an endpoint. The following sections are covered:
Applies to the following Sophos products and versions Sophos Endpoint Security and Control 10.8.2
Once testing has been done to determine that the Exploit Prevention feature is causing performance issues (as followed from Sophos Endpoint Security and Control: Basic troubleshooting), the steps below must be followed to find which specific component is responsible.
On the affected endpoint experiencing the performance issue:
Note: Do not uncheck the Enable exploit prevention or it will disable the entire feature.
If you've spotted an error or would like to provide feedback on this article, please use the section below to rate and comment on the article. This is invaluable to us to ensure that we continually strive to give our customers the best information possible.
Every comment submitted here is read (by a human) but we do not reply to specific technical questions. For technical support post a question to the community. Or click here for new feature/product improvements. Alternatively for paid/licensed products open a support ticket.