Applicable Version: 10.00 onwards
Quarantine Digest (previously known as Spam Digest prior to Cyberoam firmware version 10.04.4 Build 028) is the listing of all Emails that are identified as Spam and quarantined by Cyberoam Anti Spam Engine. Cyberoam sends the Quarantine Digest in the form of an Email to all users as per the configured frequency, which can be hourly, daily or weekly. From the digest, users can sort through the quarantined mails and, if necessary, release them to their personal inboxes.
In case of a High Availability (HA) Cluster configured in Active-Active Mode (HA Load Balancing), the Quarantine digest is compiled and sent to users by both Cyberoam Appliances separately.
Configure Quarantine Digest in Cyberoam that is sent to end users daily at 11 AM.
You must be logged on to the Web Admin Console as an administrator with Read-Write permission for relevant feature(s).
Step 1: Configure Quarantine Digest
Go to Anti Spam > Quarantine > Quarantine Digest Settings and check Enable Quarantine Digest. Specify parameter values as mentioned in table given below.
Send Email Daily At 11 Hour(s) 00 Minute(s)
Specify the Quarantine Digest mail frequency.
Specify Email Address from which the mail should be sent.
Specify mail sender name
Reference “My Account” IP
Select Interface/Port IP from the ‘Reference “MyAccount” IP’ dropdown list.
User My Account link in Digest mail will point to this IP Address. User can click the link to access his quarantined messages and take the required action. The users not falling under the specified Interface will have to access the quarantine mail directly from their MyAccount.
Enable if you want each user to override the Digest Setting i.e. user can disable the digest service so that they do not receive the Spam Digest.
Click Send Test Mail to send a test Digest to specified Email Address. Click Apply to save changes.
Step 2: Customize Individual User Settings (Optional)
Uncheck checkbox against user(s) to whom Quarantine Digest is NOT to be sent. Here, we have unchecked against user mary.stein.
Click Apply to save changes.
Alternately, you can change individual user settings by going to Identity > Users > Users and customizing user settings.
Document Version: 2.1 – 27 August, 2014
Every comment submitted here is read (by a human) but we do not reply to specific technical questions. For technical support post a question to the community. Or click here for new feature/product improvements. Alternatively for paid/licensed products open a support ticket.