This article describes the steps to convert an SG-series UTM appliance into an XG-series appliance running Sophos Firewall Operating System (SFOS) firmware.
The following sections are covered:
Applies to the following Sophos products and versions Sophos UTM
Before you attempt this procedure, do the following:
Firmware installed. Press y to reboot when done
You have now successfully converted your SG appliance to an XG appliance. Your UTM9 license is deactivated and is no longer valid.
If you’ve uploaded the wrong UTM9 license file, do the following:
Your support request has been logged and Sophos Customer Care will re-activate the license. However, this would invalidate the XG license that was created during the conversion.
If you've spotted an error or would like to provide feedback on this article, please use the section below to rate and comment on the article. This is invaluable to us to ensure that we continually strive to give our customers the best information possible.
Every comment submitted here is read (by a human) but we do not reply to specific technical questions. For technical support post a question to the community. Or click here for new feature/product improvements. Alternatively for paid/licensed products open a support ticket.