After an installation of the SafeGuard Device Encryption Client, the initial reboot stops, showing a no init error message on computers based on Intel Haswell microarchitecture (e.g. Dell Latitude E7440, E7240, E5540, E5440, Lenovo T440, X240).
Applies to the following Sophos products and versions SafeGuard Device Encryption 6.0SafeGuard Device Encryption 6.10.0
When booting the machine, use the Shift+F6 hotkey combination to load the SafeGuard POA in Int13 mode instead of ATA mode.
NOTE: Depending on your hardware, it might be necessary to switch the Operation mode in the BIOS of the hardware from RAID On to AHCI.
If you've spotted an error or would like to provide feedback on this article, please use the section below to rate and comment on the article. This is invaluable to us to ensure that we continually strive to give our customers the best information possible.
Every comment submitted here is read (by a human) but we do not reply to specific technical questions. If you need technical support please post a question to our community. Alternatively for licensed products open a support ticket.