The Sophos Community will be offline for scheduled maintenance this Saturday, May 27th, at 13:00 UTC for approximately 1 hour. Apologies for any inconvenience caused.
"Wanna" ransomware outbreak. Please see this Sophos article sophos.com/kb/126733 for advice on how to protect your organization. Immediate action recommended.
This article explains how to create a DSL (PPPoA/PPTP) Ethernet interface on the Sophos UTM.
Similar to PPPoE, some ISPs require PPPoA type connections in order to connect to their network. PPPoA connections use the PPTP protocol to establish a layer 2 tunnel from the client (in this case UTM) to the provider modem. Similar to PPPoE connections, access to the network is controlled by username and password validation. This should only be used if required by the ISP. Use this interface type when you are:
Do NOT use this interface type if:
This article focuses on a single interface type. To learn more about other interface types, please view KB article 118899.
Known to apply to the following Sophos product(s) and version(s) Sophos UTM
Interfaces may be added and edited in the WebAdmin interface under: Interfaces & Routing | Interfaces | Interfaces.
Modem IP: It may be necessary to manually specify the IP address of the DSL Modem. If so, enter the correct IP here. The correct value must be supplied by the provider.
NIC Address: Enter the IP of the UTM interface which will be connecting to the DSL modem. This should not need to be changed unless the Modem IP required changing. Be sure that the IP entered here is in the same subnet as the Modem IP above.
NIC Netmask: Enter the Subnet of the UTM interface which will be connecting to the DSL modem. This should not need to be changed unless the provider recommends a different subnet mask.
Ping Address: The address entered in this field will be monitored via ICMP Pings. If the host fails to respond, the UTM will consider the connection broken. This should typically be set to one of the DNS server IPs given by the provider.
MTU: The default value of 1492 is the typical value required for DSL connections. It may be apropriate to change this if connecting to ISPs that require smaller MTU values.
Daily Reconnect: DSL conections must reconnect periodically. This setting allows admins to control exactly when that reconnection will occur. By choosing a time that will be non-disruptive to network users, unexpected internet interruptions can be avoided.
Reconnect Delay: During the daily reconnect, the system will wait the specified amount of time after disconnecting before attempting to reconnect to the provider. This setting has no effect unless Daily Reconnect is enabled, and usually does not need to be changed. In some rare cases, the provider may not behave correctly if the client connects too quickly after disconnecting. In these cases, you may have to extend the reconnect interval.
Displayed max: (Optional) The displayed max value is a numeric field that is used for display purposes only. Entering the correct value in this field to match the available bandwidth provided on this link, allows the UTM to show accurate percentage graphs for each interface on dashboard. This has no impact on network behavior, as it is only used for display purposes.
Every comment submitted here is read (by a human) but we do not reply to specific technical questions. If you need technical support please post a question to our community. Alternatively for licensed products open a support ticket.