Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 7 replies
  • Subscribers 5 subscribers
  • Views 17014 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Help? No File Encrypted Using Fast Initial Encryption

HendraBozzie

I've tried to encrypt the hard drive Boot Volume with Fast Initial Encryption mode, and then I check the status of encryption in Explorer> (drive letter)> Properties> Encryption tab and I see a list of the key.

But, when I check on the Drive letter> File encryption> Show encryption state and at General information it says "None of the selected files are encrypted", and I check also one file "This file is not encrypted." Why?

Has anyone experienced the same thing? Help me, anyone can provide the solution?

Thanks.

:36925


This thread was automatically locked due to age.
Parents
  • 0

    Hi Dennis,

    you can find a list of command line parameters for SafeGuard Enterprise Client in the installation manual or in following KBA:

    SafeGuard Enterprise Client: description of ADDLOCAL command line parameters for installation

    This article describes the parameters you can use when the SafeGuard Client installation is done using msiexec and ADDLOCAL.

    The terminology / module names for the different encryption modes (file vs full/whole disk encryption) in SafeGuard Enterprise is:

    Full Disk Encryption

    • Volume Based Encryption
    • BitLocker (uses Windows integrated encryption options managed by SafeGuard)

    File Based Encryption

    • Data Exchange (for files on removables) or
    • File Share (for files on the local machine / network storage) or
    • Cloud Storage (for files stored in the cloud using any supported cloud provider)

    Regards,

    ChrisD

    :51344
Reply
  • 0

    Hi Dennis,

    you can find a list of command line parameters for SafeGuard Enterprise Client in the installation manual or in following KBA:

    SafeGuard Enterprise Client: description of ADDLOCAL command line parameters for installation

    This article describes the parameters you can use when the SafeGuard Client installation is done using msiexec and ADDLOCAL.

    The terminology / module names for the different encryption modes (file vs full/whole disk encryption) in SafeGuard Enterprise is:

    Full Disk Encryption

    • Volume Based Encryption
    • BitLocker (uses Windows integrated encryption options managed by SafeGuard)

    File Based Encryption

    • Data Exchange (for files on removables) or
    • File Share (for files on the local machine / network storage) or
    • Cloud Storage (for files stored in the cloud using any supported cloud provider)

    Regards,

    ChrisD

    :51344
Children
No Data
Unfiltered HTML