Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 11 replies
  • Subscribers 5 subscribers
  • Views 29063 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SGE 5.60 - autologon issue

secadm

Hi everyone,

I upgraded SGE and 3 clients to 5.60 and one of the upgraded clients has problem with Autologon / POA. Installation process completed successfully and connection with the server exists, but after reboot I can see message "Autologon will continue shortly." everytime. Two of the upgraded clients have no problems. Could anyone tell me what might be wrong? I have to give this laptop back to one of manager, so problem is quite urgent.

Edit: I reinstalled Windows 7 a few times ( with disk format) with the same effect. In the status pane of SGN Client I can see: SGN user state is pending and Data packets prepared for transmission = 2. Additionally in the Management Center in inventory section for this machine POA checkbox is unchecked, but in the policy POA is enabled.

I have to decide and tell to my principal if it is a problem with hardware ( so they have to buy another laptops) or it is a problem with software.

:12969


This thread was automatically locked due to age.
Parents
  • 0

    Hi all,

    please note when removing the MRB from an encrypted machine this can cause severe side effects and in the worst case the machine will become unusable!

    In this case it seems as if the POA boot is working fine but the communication between client and server is not working properly which cannot be fixed with a hotkey at POA level or NOATA parameter as this only affects the boot and not the communication.

    Regards

    Dan

    :13151
Reply
  • 0

    Hi all,

    please note when removing the MRB from an encrypted machine this can cause severe side effects and in the worst case the machine will become unusable!

    In this case it seems as if the POA boot is working fine but the communication between client and server is not working properly which cannot be fixed with a hotkey at POA level or NOATA parameter as this only affects the boot and not the communication.

    Regards

    Dan

    :13151
Children
No Data
Unfiltered HTML