Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 11 replies
  • Subscribers 5 subscribers
  • Views 29065 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SGE 5.60 - autologon issue

secadm

Hi everyone,

I upgraded SGE and 3 clients to 5.60 and one of the upgraded clients has problem with Autologon / POA. Installation process completed successfully and connection with the server exists, but after reboot I can see message "Autologon will continue shortly." everytime. Two of the upgraded clients have no problems. Could anyone tell me what might be wrong? I have to give this laptop back to one of manager, so problem is quite urgent.

Edit: I reinstalled Windows 7 a few times ( with disk format) with the same effect. In the status pane of SGN Client I can see: SGN user state is pending and Data packets prepared for transmission = 2. Additionally in the Management Center in inventory section for this machine POA checkbox is unchecked, but in the policy POA is enabled.

I have to decide and tell to my principal if it is a problem with hardware ( so they have to buy another laptops) or it is a problem with software.

:12969


This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    Same for me but with 5.50.x, solution in my case was to start SGE client installation with NOATA=1 parameter.

    Just for your information you don't have to reinstall windows just boot from Win 7 recovery CD and run bootrec.exe /fixmbr (I had to run bootrec.exe /fixboot also) boot normally to Windows, uninstall SGE client and install it again with NOATA parameter.

    Of couse this apply to nonencrypted disk.

    Regards,

    Igor

    :13145
Reply
  • 0

    Hi,

    Same for me but with 5.50.x, solution in my case was to start SGE client installation with NOATA=1 parameter.

    Just for your information you don't have to reinstall windows just boot from Win 7 recovery CD and run bootrec.exe /fixmbr (I had to run bootrec.exe /fixboot also) boot normally to Windows, uninstall SGE client and install it again with NOATA parameter.

    Of couse this apply to nonencrypted disk.

    Regards,

    Igor

    :13145
Children
No Data
Unfiltered HTML