This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Won't load Windows 10 after enabling BitLocker.

Hello, I'm a new member here.

I have a computer at my company that have Sophos Endpoint Agent installed.  I turned off BitLocker to clone the drive with SSD.

After cloning, I had to change from Legacy to UEFI mode so it will boot to Windows OS on the new SSD.

It booted to Windows fine on the new SSD.

But when I re-enabled BitLocker, it asked me to create a password, and I did.  It said it needs a restart.  But since then, it shows up a blank blue screen.

Then after 30 seconds, it shuts down the computer automatically.

I replaced SSD drives on a few other computer that had Sophos also installed, and they didn't have this problem.



This thread was automatically locked due to age.