CyberoamOS (Read Only)

Forum Vlan & Interface

CyberoamOS (Read Only) requires membership for participation - click to join

Thread Info

State Not Answered
Locked Locked
Replies 3 replies
Subscribers 1 subscriber
Views 4826 views
Users 0 members are here

Options

Suggested

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Vlan & Interface

Samer Waleed over 5 years ago

Hi All,

I have Cyberoam CR100iNG

I face issue with redirect the traffic, i need to forward some of Vlan's to specific interface on firewall.

for example Vlan 10 use port E for access WAN

Thank you,

This thread was automatically locked due to age.

Parents

0 Keyur over 5 years ago

Hi Samer Waleed

If your VLAN traffic is already coming on the Cyberoam, you can create LAN to WAN firewall rule for Specific IP network and use "Route through Gateway" as Port E ISP and put the rule on top in LAN TO WAN zone.

Regards,

Keyur
Community Support Engineer | Sophos Support
Sophos Support Videos | Knowledge Base | @SophosSupport | Sign up for SMS Alerts |
If a post solves your question use the 'This helped me' link
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Keyur over 5 years ago

Hi Samer Waleed

If your VLAN traffic is already coming on the Cyberoam, you can create LAN to WAN firewall rule for Specific IP network and use "Route through Gateway" as Port E ISP and put the rule on top in LAN TO WAN zone.

Regards,

Keyur
Community Support Engineer | Sophos Support
Sophos Support Videos | Knowledge Base | @SophosSupport | Sign up for SMS Alerts |
If a post solves your question use the 'This helped me' link
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Samer Waleed over 5 years ago in reply to Keyur

Dear Keyur,

Thank you

Created. The issue still exists. Firewall not responding to routing rule for Vlan 30.

it's use rule #1 ( LAN WAN AnyTraffice )
Cancel
Vote Up 0 Vote Down

Cancel
0 Keyur over 5 years ago in reply to Samer Waleed

Hi Samer Waleed

If the traffic does not traverse from the intended rule then there should be an issue with firewall configuration or static route should be check. Please make sure to apply MASQ in the firewall rule.

I would request you to open a support case to investigate the issue further.

Regards,

Keyur
Community Support Engineer | Sophos Support
Sophos Support Videos | Knowledge Base | @SophosSupport | Sign up for SMS Alerts |
If a post solves your question use the 'This helped me' link
Cancel
Vote Up 0 Vote Down

Cancel