Como resetear el UTM con el boton fisico?

Hello,

Apologies, I can only answer in English. To confirm, are you trying to reset your Cyberoam device or put it into bridge mode (or both)?

Thank you,

Bob

Hello,

Apologies, I can only answer in English. To confirm, are you trying to reset your Cyberoam device or put it into bridge mode (or both)?

Thank you,

Bob

I need to reset the cyberoam with the physical button. How do I do it? What is the procedure.

Hello,

This article should help: https://kb.cyberoam.com/default.asp?id=1854

Thank you. 

Bob

I can not access the Cyberoam, not the access key, if not why I do not know how to access.

Hi Joaquin,

You can configure the subnet IP address of the Cyberoam interface on a system and directly connect it to the LAN interface. The default gateway IP address for the XG is 172.16.16.16. The IP Address configuration should be:

IP Address: 172.16.16.90

Subnet: 255.255.255.0 

Gateway: 172.16.16.16

If the IP address is changed post deployment then you can check the IP address by taking the console access through a serial cable to the UTM and go to option 1. Network configuration and find the configured IP address on the LAN interface. Refer to Setup Serial Console Connection using PuTTy.

Thanks